FOLAJET ARF

Suitable for Thermal printers

Suitable for Piezo printers

Suitable for Dye Ink

Fast dry coating

Anti-Reflective Surface

Suitable for most Ink Jet Plotters using dye- or pigmented inks.

Useable on most large-format Ink Jet printers using Pigmented ink systems. Limited suitability with when using dye inks.

Useable on most large format Ink Jet printers using solvent UV curing ink systems.

Not compatible with oil and solvent based systems.

Please note:
Not suitable for adhering onto soft PVC, copper or aluminium. This is due to the active sticking substances which may permanently damage the surface. Tack Jet P-WO is difficult to remove from some substrates such as PE and PP if the surfaces are chemically or corona treated.

Suitable for most Ink Jet Plotters using waterbased dye inks.

Please observe the specifications for your printer and the RIP software.

A preconditioning period of 24 hours within the printing environment is recommended.

Printer mode: fine art paper, mat coated paper o.s.

For Outdoor Use, laminating is recommended.

Switch off automatic cutting device (damage to print heads and cutting knives).

Ink Load: approx. 260 - 300% (may vary according to ink system).

Ink Load: approx. 250 - 290 % (may vary according to iink system).

Outdside exposure (weathering):
up to 3 months without lamination possible, for longer periods lamination recommended.

Please follow the handling instructions supplied with this product as well as the machine manufacturers manual.

Between 15-30°C and 30-70% r.h.

Printer set-up: vinyl, coated paper, or similar

Printing quality: “best”, “high“, or similar

Print image in mirror mode in "best quality"

Printer Mode: photo quality, coated paper, o.e.

Lamination: cold or heat laminates (low-temp) possible but not necessary due to water-proof prints.

Lamination: cold or heat lamination. To increase UV Protection, laminating is recommended.

Lamination: cold laminates possible, Hot lamination: tests based on the application temperature might be necessary.

For correct feeding please follow the equipment suppliers manual.

Cold peeling of interleaving paper

Use single side adhesive for non self-adhesive displays and signs or a double side adhesive for self adhesive displays and signs.

Ink Load: approx. 220 - 280 % (may vary according to ink system).

Ink Load: approx. 280 - 300 % (may vary according to ink system).

Lamination: cold laminates possible

For optimal half-tone reproductions it is essential to make settings with a correct linearization process.

Avoid fingerprints on printing side.

Lamination :cold or heat lamination. For outdoor application lamination is recommended. Before laminationg let the prints dry for minimum 2 hours.

Please follow the special handling instructions (instruction sheet).

Unopened in original packaging storage time is minimum 1 year after shipment (under recommended storage conditions).

Store in a cool and dry place at a room temperature of 15 - 25°C and at a humidity of 30 - 60%.